Description Specification PLASTIC ADHESIVE REPLAST® EASY FAST For REPLAST® Easy plastic repair system An adhesive for virtually every type of plastic No need for inconvenient use of different types of adhesive Can be used for repairs and structural bonding Special positive mixer Optimum mixing with minimum volumes Low adhesive loss (waste) Quick to harden Further work, such as sanding, is possible within an extremely short period of time Excellent chemical resistance Resistant to a wide range of liquids, such as petrol, many lubricating oils and ethyl acetate Solvent-free Application area Cars Spoilers, Radiator grills Panel clips Bumpers Brackets on headlights and radiators etc HGVs and buses Aprons Bumpers Air intake pipes Wheel arches etc. Motorcycles All panelling Instructions The substrate must be capable of bearing loads and must be clean, dry and free from grease and rust. Old adhesive residues must also be removed. To do so, clean the surface with the plastic cleaner and apply the primer. The flash-off time must be observed. Discard some adhesive before screwing on the mixer nozzle. The first 2 cm of adhesive from the mixer nozzle should also not be used. When applying the adhesive, the mixer should remain in the adhesive to prevent bubbles forming. Observe the work instructions. Technical Information Contents 50 ml Chemical basis Two-component polyurethane Processing time 1.5 min Colour Black Density 1.225 g/cm³ Min. initial strength 10 min Min./max. processing temperature 15 to 25 °C Min./max. temperature resistance -30 to 100 °C Silicone-free Yes Notice There may be adhesion problems in individual cases due to the coatings and release agents used in some cases in the plastic production process. Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluor ethylene) plastics. Check material compatibility on an invisible area if necessary. The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.
